Dolmar HT-2576 E Instruction Manual Page 15
- Page / 88
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
15
STORAGE
MAINTENANCE SCHEDULE
General Engine assembly,
screws and nuts
Visual inspection for damage and tightness
Check for general condition and security
After each refuelling Throttle lever
Safety lock key
STOP switch
Functional check
Functional check
Functional check
Daily Air lter
Cooling air duct
Cutting tool
Idling speed
To be cleaned
To be cleaned
Check for damage and sharpness
Inspection (cutting tool must not move)
Weekly Spark plug
Mufer
Inspection, replace if necessary
Check and if necessary clean the opening
Quarterly Suction head
Fuel tank
To be replaced
To be cleaned
Shutting down procedure Fuel tank
Carburetor
Empty fuel tank
Operate until engine runs out of fuel
FAULT LOCATION
Fault System Observation Cause
Engine not starting or
under difculties
Ignition system Ignition spark is present Faulty fuel supply or compression system, mechanical defect
No ignition spark STOP-switch operated, wiring fault or short circuit, spark
plug or connector defective, ignition module faulty
Fuel supply Fuel tank lled Incorrect choke position, carburetor defective, suction head
(gas line lter) dirty, fuel supply line bent or interrupted
Compression Inside of engine Cylinder bottom gasket defective, crankshaft seals damaged,
cylinder or piston rings defective
Outside of engine Improper sealing of spark plug
Mechanical fault Starter not engaging Broken starter spring, broken parts inside of the engine
Warm start problems Tank lled
Ignition spark existing
Carburetor contaminated, have it cleaned
Engine starts but dies
immediately
Fuel supply Tank lled Incorrect idling adjustment, suction head or carburetor
contaminated
Fuel tank vent defective, fuel supply line interrupted, cable or
STOP-switch faulty
Insufcient
performance
Several systems may
simultaneously be affected
Engine idling Air lter contaminated, carburetor contaminated, mufer
clogged, exhaust duct in the cylinder clogged
When keeping the machine in storage for a long time, drain fuel from –
the fuel tank and carburetor, as follows: Drain all fuel from the fuel
tank.
Remove the spark plug and add a few drops of oil into the spark plug –
hole. Then, pull the starter gently to conrm that oil lm covers the
engine inside and tighten the spark plug.
Clear dirt or dust from the cutter blade and outside of engine, wipe –
them with a oil-immersed cloth and keep the machine at a place as
dry as possible.
Drain fuel
Humidity
- (Original instructions) 2
- SAFETY INSTRUCTIONS 3
- Starting up the Hedge Trimmer 4
- Refuelling 4
- Method of operation 5
- Maintenance instructions 5
- First aid 5
- Packaging 5
- TECHNICAL DATA 6
- FUELS/REFUELLING 8
- PRECAUTIONS BEFORE STARTING 9
- STARTING THE MACHINE 10
- STOPPING THE MACHINE 10
- OPERATION OF THE MACHINE 11
- MAINTENANCE INSTRUCTIONS 12
- Suction head in the fuel tank 14
- Daily checkup and maintenance 14
- MAINTENANCE SCHEDULE 15
- FAULT LOCATION 15
- Français 16
- CONSIGNES DE SÉCURITÉ 17
- Plein de carburant 18
- Méthoded’utilisation 19
- Maintenance 19
- Premiers secours 19
- Emballage 19
- DONNÉES TECHNIQUES 20
- HT-2556 D 21
- HT-2576 E 21
- Mélange huile/essence 22
- Manipulation du carburant 22
- DEMARRAGE 23
- DEMARRAGE DE LA MACHINE 24
- ARRET DE LA MACHINE 24
- FONCTIONNEMENT DE LA MACHINE 25
- INSTRUCTIONS DE MAINTENANCE 26
- STOCKAGE 29
- PROGRAMME D’ENTRETIEN 29
- LOCALISATION DES DÉFAUTS 29
- (Originalanweisungen) 30
- SICHERHEITSVORSCHRIFTEN 31
- Auftanken 32
- Wartungsvorschriften 33
- Erste Hilfe 33
- Verpackung 33
- TECHNISCHE DATEN 34
- KRAFTSTOFFE/NACHFÜLLUNG 36
- VORSICHTSMASSNAHMEN VOR 37
- MOTORANLASSUNG 37
- ANLASSUNG DES MOTORS 38
- ABSCHALTEN DES MOTORS 38
- BEDIENUNG DES GERÄTS 39
- WARTUNGSANLEITUNGEN 40
- Schmierung 41
- Tägliche Prüfung und Wartung 42
- LAGERUNG 43
- WARTUNGSPLAN 43
- FEHLERSUCHE 43
- Italiano 44
- NORME DI SICUREZZA 45
- Avviamento del Tosasiepi 46
- Rifornimento 46
- Metodo di funzionamento 47
- Pronto soccorso 47
- Imballaggio 47
- DATI TECNICI 48
- MISCELA DI CARBURANTE E OLIO 50
- Conservazione del carburante 51
- AVVIAMENTO DELLA MACCHINA 52
- ARRESTO DELLA MACCHINA 52
- FUNZIONAMENTO DELLA MACCHINA 53
- MANUTENZIONE 54
- Pulizia della marmitta 56
- IMMAGAZZINAGGIO 57
- PIANO DI MANUTENZIONE 57
- LOCALIZZAZIONE DEI GUASTI 57
- Nederlands 58
- VEILIGHEIDSVOORSCHRIFTEN 59
- Starten van de Heggescharen 60
- Bijvullen 60
- Bedieningsmethode 61
- Onderhoudsvoorschriften 61
- Verpakken 61
- TECHNISCHE GEGEVENS 62
- MENGEN BENZINE EN OLIE 64
- Brandstofopslag 65
- STARTEN VAN DE MACHINE 66
- STOPPEN VAN MACHINE 66
- GEBRUIK VAN DE MACHINE 67
- ONDERHOUDSINSTRUCTIE’S 68
- Zuigkop in de benzinetank 70
- Reinigen van de uitlaatpijp 70
- MACHINE-OPSLAG 71
- ONDERHOUDS-SCHEMA 71
- STORING LOKALISEREN 71
- SÍMBOLOS 72
- INSTRUCCIONES DE SEGURIDAD 73
- Arranque del cortasetos 74
- Repostaje 74
- Embalaje 75
- Método de funcionamiento 75
- Primeros auxilios 75
- DATOS TÉCNICOS 76
- COMBUSTIBLE/REPOSTAJE 78
- FUNCIONAMIENTO 79
- PARADA DE LA MÁQUINA 80
- OPERACIÓN DE LA MÁQUINA 81
- Aladodelascuchillas 82
- Ajuste de las cuchillas 82
- PROGRAMA DE MANTENIMIENTO 85
- LOCALIZACIÓN DE AVERÍAS 85
- 885119A939 88
Related products and manuals for Power hedge trimmers Dolmar HT-2576 E
(54 pages)© 2020, manymanuals.com. All rights reserved. | 1.135 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals