Dolmar POLE HEDGE MH-2556 Instruction Manual download pdf (Page 12)

STOPPING THE ENGINE

1. Release the throttle lever.

2. Push the I-O switch to the "O" position (5) to stop the engine.

The cutter blades of the pole hedge trimmer should not move when the throttle

lever is released.

- The correct idling speed is 3000 min

-1

. If necessary, adjust the idling speed using

the idling adjustment screw (reduce revs until the cutter blades do not move

anymore).

• Turn screw clockwise: Idling speed increases

• Turn screw counter-clockwise: Idling speed decreases.

Allow an adequate difference between the idling rate and the rate at which the

clutch engages (reduce idling speed further if necessary). Should the cutter

blades still move in spite of accurate idling speed settings, consult your

nearest authorized service agent.

• The clutch should engage at a minimum rate of 4000 min

-1

• Check that the STOP switch, the lock-off lever and the throttle lever are all

functioning properly.

CHECKING AND ADJUSTING THE IDLING SPEED

(5)

slow High

Idling adjustment screw

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 53 54

No comments

Dolmar POLE HEDGE MH-2556 Instruction Manual Page 12