Dolmar MS-22C Instruction Manual download pdf (Page 12)

CORRECT HANDLING OF MACHINE

Attachment of shoulder strap

– Adjust the strap length so that the cutter blade will be kept parallel with the

ground.

Detachment

– In an emergency, push the notches (1) at both sides, and you can detach

the machine from you.

Be extremely careful to maintain control of the machine at this time. Do not

allow the machine to be deflected toward you or anyone in the work

vicinity.

WARNING: Failure to maintain complete control of the machine at all could

result in serious bodily injury or DEATH.

PUTTING INTO OPERATION

Observe the applicable accident prevention regulations.

Starting

Move at least 3m away from the place of refuelling. Place the string trimmer on a clean piece of ground taking care that the nylon cutting

head does not come into contact with the ground or any other objects.

Cold start

For machine with Loop Handle

– Push the I-O switch (1) in the direction shown by the arrow.

– First place the machine on the ground.

– Give a gentle push on the primer pump (1) repeatedly (7-10 times) until fuel

comes into the primer pump.

– Push the choke button (2) to the position " "

– Firmly hold the clutch case by your left hand, as illustrated.

– Slowly pull the starter grip until resistance is felt and continue with a smart

pull.

– Do not pull out the starter rope to its full extent and do not allow the starter

handle to be retracted without control, but ensure that it is retracted slowly.

– Repeat the starting operation until initial ignitions are heard.

– When the engine starts, please open the throttle lever a little. The choke

button being automatic, it returns to original position " ".

– Run the engine for approximately one minute at a moderate speed before

applying full throttle.

Hanger

(1)

(2)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 52 53

No comments

Dolmar MS-22C Instruction Manual Page 12